How should people go about maintaining their roof? The first thing to do is to remove any plants or moss that has started growing on the roof. Rub the slates or tiles with a hard bristle brush soaked in water. Quackgrass and synthetic materials (nylon, polyester…) are well suited, while metal brushes should not be used on metal: it scratches! Take as much care as possible when cleaning the roof and any associated connections. Then rinse the roof off with a hose or spray gun from top to bottom in the direction of the slope. High-pressure cleaning, which is sometimes recommended, is not recommended on slate or enameled or varnished tiles. The power of the jet may alter its protective layer, whether natural or reconstituted (concrete, fiber-cement, etc.).

How can one protect their roof? It is advisable to complete each cleansing with a curative and preventive treatment. This is essential when it comes to roof repair and any materials used should be obtained through reputable Roofing Contractors in Gig Harbor. Most of the cleaners are ready to use or can be diluted in water, but these products should be used in dry weather and in the absence of wind. Acting in depth, they are formulated to destroy the remains of parasitic plants and delays any future breakouts. Their duration of action is about three years. Antifoam should dry on its own between eight days to three weeks, depending on the directions. As a result, it can be covered with a water repellent or a waterproofing coat, which will extend the service life of the roof.

Aging seals are areas of weakness. On a roof that is still healthy, seals and slots are easily clogged. When the roofing materials begin to break down or disintegrate, a punctual repair is not enough. Owners have to do the whole process over again. Watch the weather because dry weather is a must when it comes to repairing a roof. Leakage due to perforations or weld wear can also affect metal sealing or connecting fittings: flaps, closures, nets, flashings, etc. To remedy this, there are bituminous strips, which are laid down cold (self-adhesive) or through hot temps (heat stripper, blowtorch, and so on).